Phyzen Sport Tiger 2K(飞人水性双组份飞虎体育面漆)
PhyzenSportTiger2Kis a water-based topcoat specifi-cally designed for sports wood flooring, using nano technol-ogy two-component polyurethane. lt is mainly used as atopcoat for sports wood flooring. This product is designedspecifically for the highest anti slip requirements of sportswooden flooring.This product has DIN18032-2:2001 anti slipcertification and complies with GB18581-2020 standards forsoluble precious metals, benzene, toluene, ethylbenzene,xylene, volatile organic compounds, and free formaldehyde.According to the requirements ofGB23999-2009 for wearresistance and hardness, the hardness, elasticity, adhesion,wearresistance,and anti-corrosion and rust prevention ofthis product are at a high-qualitylevel among similarproducts.
Productcharacteristics
Suitable for topcoat application in polishing and refurbishing processes
High solid content, high coverage, and high filling capacity
Highly wear-resistant,anti-corrosion, waterproof, rust proof,and scratch resistant, specifically designed forsports wood flooring
Hardness, elasticity, chemical and mechanical resistance areat the global high-quality level
Has DIN18032-2:2001 anti slip certification
Good chemical resistance, wear resistance,hardness and physical properties
产品类型：双组分水性聚氨酯体育运动木地板面漆
推荐施工温度：+5℃ -+ 35℃
推荐存储运输温度：+5℃ -+ 25℃
施工工具：10±2毫米滚筒滚涂/刷涂/喷涂/涂抹器刮涂
使用方法：第一步，把0.5L固化剂与水按照1：1比例混合搅拌均匀。
第二步，把稀释后的固化剂和清水（1L）混合液体，缓缓倒入5L装的面漆，边倒边搅拌均匀。搅拌约1-3分钟即均匀，可涂刷。如有气泡，等待5分钟气泡即可自行消除。
第三步；如果觉得混合固化剂之后的面漆粘度稠，可以加入5%左右的水稀释搅拌后涂刷。
推荐涂抹率：100克/平方米
尘干：35分钟（在20度温度和65%相对含水率条件下）
指干：120分钟（在20度温度和65%相对含水率条件下）
添加固化剂后可施工时间：120分钟内完成施工，否则不能再使用。
砂光打磨：约12小时（在20度温度和65%相对含水率条件下）
光泽度：80±5度
木材氧化：轻微
填充能力：好
耐化学物理性能：优秀
包装：5.5L (5L+0.5L)
工具清洗：清水
保质期：在未开封的密封容器内，自生产日期起18个月